The reducer is manufactured by Greenglobe fuel Solutions. It is a two stage pressure reducer for sequential injection system which provides the constant outlet flow in all driving conditions.The outlet pressure of reducer is adjustable to obtain the best performance and also has connection for pressure manometer.
The ECU is manufactured by AEB Italy It comprises of changeover Micro switch, Map sensor, heat resistant wiring harness and ECU. The electronic control unit is technological advanced chip with software which is compatible with BS-3,BS-4 AND BS-6 vehicles.It is equipped with 48 pin advanced processor and has protection against heat and water infiltration.
The injector rail is manufactured by Valtek (Italy) and is made to inject the controlled quantity of CNG at specific intervals of time as per vehicle requirement.
It comprises of high pressure steel tubing, high quality nuts, bolts, washers, clips, screws, ferrul nuts which are extensively tested in different environmental conditions and meet international standards.
It is made of synthetic rubber and used to send gas from the regulator to injector rail and intake manifold of the vehicle.
The pressure gauge gives the indication and signal to the changeover switch of the available quantity of CNG in the tank.
It is the valve through which the CNG is refilled in the gas cylinder,it can be installed in the engine room or on the backside quarter panel of the vehicle depending on the requirement.
Greco CNG reducer is a two stage pressure reducer for sequential injection system which provides the constant outlet flow in all driving conditions.The outlet pressure of the reducer is adjustable to obtain the best performance and also has connection for pressure manometer.
It comprises of changeover Micro switch,Map sensor,heat resistant wiring harness and ECU.The electronic control unit is technological advanced chip with software which is compatible with BS-3,BS-4 AND BS-6 vehicles.It is equipped with 48 pin advanced processor and has protection against heat and water infiltration.
Greco Injector Rail is made to inject the controlled quantity of CNG at specific intervals of time as per vehicle requirement.
It comprises of high pressure steel tubing, high quality nuts, bolts, washers, clips, screws, ferrul nuts which are extensively tested in different environmental conditions and meet international standards.
It is made of synthetic rubber and used to send gas from the regulator to injector rail and intake manifold of the vehicle.
The pressure gauge gives the indication and signal to the changeover switch of the available quantity of CNG in the tank.
It is the valve through which the CNG is refilled in the gas cylinder,it can be installed in the engine room or on the backside quarter panel of the vehicle depending on the requirement.